LCR-Reader Multifunction Probe Connector permits LCR-Reader to be used as a probe station. Connects to tweezer handles of LCR-Reader, replacing the gold-plated tweezer tip. Performs LCR testing in automatic or manual mode. By connecting the connector probe (e.g., alligator clip) to a certain node on the PCB, the other tweezer tip becomes a pin probe that can be moved around, promptly giving impedances at various nodes of the PCB. Automatic mode automatically determines impedance type L, C or R, and automatically selects test frequency (0.1, 1 or 10KHz) based on best accuracy. Test signal level is 0.45 Vrms. Impedance values are readily available on the screen once tweezer probe contacts a tested PCB node. Consists of a 60cm-long shielded two-wire cable with a small PCB on one end directly connecting two signal flex stripes on one of the LCR-Reader handles to a universal connector head. Shield is connected to LCR-Reader PCB ground plane. Five kinds of probes can be screwed onto the head, including alligator clip, long and short pin-probes, a spade connector and 4mm multimeter jack plug. Shielded two-wire connection is said to almost eliminate additional offsets due to parasitics of the wires. Enables measurement of larger components that do not fit between the tweezers.

Siborg Systems, secure.lcr-reader.com/catalog/

Pneumatic Actuated Keysight 307x in-circuit test fixture meets test requirements for PCBAs with high test point counts, single or dual side access, and dual stage testing. Supports ESD safe test of complex boards with 39 mil center-to-center test points. Permits testing in two stages with 80% of test contact occurring in the second stage using long travel probes. These dual stage tests usually apply for ICs that also require cooling during power up testing.

Everett Charles Technologies, ect-fsg.com/incircuit-test-fixtures

Tri-V solvent series replaces toxic cleaning chemicals such as n-propyl bromide (nPB) and trichloroethylene (TCE). Are nonflammable, and can be used on energized equipment, penetrate to clean hard to reach areas, evaporate quickly and reportedly leave no residues. Come in aerosol and bulk packaging for benchtop cleaning, immersion cleaning, or vapor degreasers. Are stabilized and safe for metals such as aluminum, magnesium, titanium and brass.

Electro-Wash Tri-V precision cleaner is nonflammable cleaner and removes flux, grease, oils, dirt, dust and other contaminants from electronic components and assemblies. Max-Kleen Tri-V removes soils including oxidized oil and grease from motors and relays. Flux-Off Tri-V flux remover is an extra-strength nonflammable solvent that removes heavy encrusted flux deposits common after circuit board assembly. Works on R, RA, RMA and synthetic fluxes.

Chemtronics, a division of Illinois Tool Works (ITW), www.chemtronics.com

Mini Swash III cleaning machine replaces StencilClean SIA. Is for low-volume PCBA cleaning. Features zero drain system with high capacity rinse, longer lifetime and usability of DI water filters, open or closed loop filtration, and traceability with barcode reader for process logging.

PBT, www.PBT-works.com